H10 Optic LED Taillight Bar for Vanquish H10 Optic
Nylon material
Voltage : 6.0 - 8.4V
Multiple flashing modes can be switched
The controller can use CH3 to switch control modes.(The VP remote control needs to set the L.F.U or R.B.U of the EPR-3C to 50% ). Connect the 1p wire to CH1(this is the signal wire! Do not reverse the connection!)
Controller CH3 Button
Single click - Turn off all lights
Double click - Steady red light & four-color light
Triple click - Car hazard light
Four clicks - Four-color light flashing
Five clicks - On off turn signal light mode
Module turn signal light calibration:
1. Power off the receiver
2. Plug the module plug into the receiver
3. Insert the 3P plug into the button channel
4. Insert the 1P plug into the steering channel
5. Turn on the remote control (do not press any channel buttons after turning it on)
6. Press and hold the button at the bottom right of the module
7.Power on the receiver
8. When powered on, the light bar will flash red quickly
9. Release the module pairing button
10. Within 1 second, the light bar will flash white quickly, indicating that the pairing is complete
